What are characteristics of drying methods of KENKI DRYER？ / sludge drying, slurry drying

What are characteristics of drying methods of KENKI DRYER？
There are two.
1）Self-cleaning screw （Patented）
2）Four methods of drying process（Patented）

　1）Self-cleaning screw
Drying no other one can do. Drying of any sticky, adhesive stuff

Self-cleaning screw
Even materials stuck on the blades of one screw, blades of the other screw peel the materials off as they rotate. No sticky or adhesive materials can stick on the blades. Hence, any kind of material can be dried without being clogged inside the dryer.

Agitation to dry inside of the material
Unique shaped screw blades agitate the material enough, and the material can be dried completely by being heated from deep inside.

There is no carbonization of the material
There is no carbonization of the material on surface of screw blades and screw shafts because of low-temperature drying.

Unique shaped screw blades agitate the material enough, and the material can be dried completely by being heated from deep inside.
Prevention of being stuck and clogged inside of the dryer. Agitation to heat and dry inside of the material.

Patented in JAPAN, US, TAIWAN
Patent applied in FRANCE, CHINA, KOREA, EU, CANADA

　2）Four methods of drying process

　Crushing and drying
A material supplying device which has uniquely shaped blades being attached to two shafts and rotating constantly. It smashes solid and sticky materials such as sludge, and carries smoothly to the main body of the dryer. Steam are supplied into the two shafts so that the shafts and the blades are continuously heated.

　Agitation drying
This is the main section of this dryer. Unique and patented blades are attached to two shafts set inside of the main body of the dryer, and the blades dry, agitate and carry materials without clogging. Steam are supplied into the two shafts so that the shafts and the blades are continuously heated.

　Circulation drying
Air inside of the dryer is drawn in with a circulation blower and the air is blown back to the dryer after heated by heat exchangers attached on the upper part of the dryer.The air blown back is aimed at the top part of the material. To blow heated air always on the top part of the materials helps to dry the materials efficiently.

　Indirect drying
A heat exchanger is attached to outside of the dryer’s trough. Steam is supplied to the heat exchanger and the side and bottom parts of the dryer are heated up continuously.

Patented in JAPAN, TAIWAN
Patent applied in CHINA, KOREA, EU, US,CANADA